Has anyone seen anything like this before? Could it be the 59.94 versus 60 thing? I'm not entirely sure how to confirm the iMac really outputs at 60 or 59.94 and if that would cause an occasional flicker or if that would just cause the output to just not work. You'll want to keep this mission-critical software on an OS that supports it. It will not receive any update to support Big Sur or Apple Silicon and issues will arise if used on Big Sur or Apple Silicon. We swapped converters with another we have and found both do it, but only with the computer connection. ProPresenter6: This version is no longer in active development. To me, that would eliminate the HDMI cable as a potential issue. The fact that the computer doesn't auto-adjust like it lost an input has me stumped though. The fact that both the TVs and the ATEM flickers tells me it is the HDMI-to-SDI converter and not somewhere else in the chain. The resolution from the iMac to the converter states 1080i60 (not sure if this is different than 59.94). Otherwise, the picture is completely clear. Today, we are going to give 6 solutions to recover your missing files after mac update to macOS 13. A MacOS (Sierra or later) setting that could cause media loss. Missing files after mac update is definitely a disaster. The output on the ATEM drops as well and comes back. Have a ProPresenter problem Try these things first. We are running into the following issue: every so often we randomly have the TVs flicker like the input dropped and came back (roughly a second). Now turn printer ON, wait until it fully boots. Turn computer ON wait until it fully boots. Turn both computer and printer OFF, wait 30 seconds. If you have configured your printer in a setup where it is connected to the USB port of your Mac, disconnect it. Fixes an issue where the Current and Next Slide Previews were flipped. Step 5 Printer is Connected to the USB Port. The iMac also has another output connected via VGA to a TV we use as a stage display in the back. Fixes an issue with ProPresenter 6 Migration. From there, one output goes to an ATEM switcher and the other runs up to an SDI-to-HDMI converter and into two TVs (one through the HDMI out, one through the SDI loop). That implies that the issue mostly occurs either because the creators of the apps are yet to release app updates that recalibrate the app to make it compatible. We currently have an iMac that goes HDMI out into an HDMI-to-SDI micro converter. I've seen what I believe are similar issues but nothing explained that sounds quite like ours that had a confirmed answer. New to the forum, but have tried searching everywhere with no luck.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |